Indesit DIF 16B1 Gebrauchsanleitung Seite 6

Anti-condensation strip
EN
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.
Advice regarding the first wash cycle
After the installation, remove the stoppers from the racks and the
retaining elastic elements from the upper rack, if any.
Immediately before the fist washing,
dispenser with water and add only then approximately 1
(see chapter entitled Rinse aid and refined salt)
kg of salt
The water may overflow: this is normal and is not a cause
for concern. Select the water hardness value
entitled Rinse aid and refined salt).
poured into the machine, the LOW SALT indicator light
switches off.
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.
20
*
completely fill the salt
(see chapter
- After the salt has been
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
*
The display provides useful information concerning the
type of wash cycle, drying/wash-cycle phase, remaining
time, temperature etc etc.
.
Technical data
* Dimensions
Capacity
Water supply pressure
Power supply voltage
Total absorbed power
Fuse
*
Only available in selected models.
(depending on the
.
width 59,5 cm
height 82 cm
depth 57 cm
13 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
7,25 – 145 psi
See appliance data plate
See appliance data plate
See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EU Waste Electrical
and Electronic Equipment
(WEEE)