Panasonic CF-VEB612A Bedienungsanleitung Seite 5

PC Card I
PC Card Eject Buttons
PC Card Slots
PC cards conforming to the PC Card standard can be
installed in the port replicator. The types of cards that
can be inserted into the slots as well as the installation
and removal methods are the same as for the PC Card
slots of the computer. Four cards may be installed at
the same time, one in each slot of the computer and
port replicator.
♦MEMO*->
• CardBus type PC Cards cannot be used in the PC Card slots of the port replicator.
• When the port replicator is connected to your computer and a total of three or more PC
Cards are being used, deactivate unnecessary equipment using [Supervisor Setup] in
the Setup Utility.
♦CAUTION*
• SRAM and FLASH ROM cards are not supported.
• When using a CardBus type card for PC Card slot of the computer, use only that card;
do not insert any other PC Cards.
• When first purchased, dummy cards* are mounted in the PC Card slots. To set PC
Cards, first remove the dummy cards. (The procedure for removing a dummy card is
the same as that for a PC Card.)
• Dummy cards are mounted in the slots to prevent dust or foreign matter from getting inside the port
replicator. Make sure a dummy card is mounted in each slot that does not contain a PC Card.