Hisense RB372N4ADE Bedienungsanleitung Seite 34

11
④
5. Unscrew the two special flange self-
tapping screws which are used for
fixing the middle hinge part, then
remove the middle hinge part that hold
the lower door in place.
NOTE: When removing the door, watch
for washer(s) between the center hinge
and the upper of the lower door that
may stick to the door. Don't lose it.
6. Place the lower door on a smooth
surface with its panel upwards.
Loose screw ③ and take down part①
and part ②, then Install door stopper-
left ④(provided in the plastic bag) and
left part ② and screw ③ to the left side
and tighten them securely.Keep part ①
with the appliance for future reference.
①Door stopper
②Stop block
③Self-tapping screw
①
②
③
④Door stopper-left
①Door stopper
②Stop block
③Self-tapping screw
①
②
③
④
7. Change screw and screw hole covers
on midde cover plate from left to right (as
shown in figure below).
screw screw hole covers
8. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts①,
then remove the lower hinge part ②by
unscrewing the special flange self-
tapping screws③.
①
②
③
①Adjustable bottom feet part
②Lower hinge part(right)
③Self-tapping screw
9.Remove part ① from the lower
hinge part(right), loose out the lower
hinge pin, change it to the reverse
hole site, and then tighten into
position, then install part ① on the
lower hinge pin.
10. Change screw hole covers on lower
cover plate from left to right (as shown
in figure below).
screw hole cover
④Door stopper-left
screw
screw hole covers
①
screw hole cover