Sunjoy A102005814 Aufbauanleitung & Nutzungshinweise Seite 6

Make sure that there is no permanent snow load. It should be removed immediately. The same applies to
rain and other forms of load. The product can be used at temperatures close to zero. However, storage of
the product must be at a temperature of at least 10 °C. If necessary, allow the fabric to warm up at a
temperature above 10 °C for a sufficient time before folding so that it does not break during folding.
Each country has different regulations for mobile structures (gazebos) and non-mobile structures. Ask
your local authorities if you need to obtain a permit to erect the product. In some countries this depends
on its size.
Observe the order of assembly of the individual parts. We recommend covering the mounting surface with
a soft surface to prevent scratching or damaging the parts.
Disassembly should be carried out in the reverse order of the assembly procedure.
CARE AND STORAGE INSTRUCTIONS
The product should be checked from time to time. Tighten and secure all fasteners of the structure to
ensure that they have not become loose. It is important to know that increased play in the connections
causes excessive stress on some parts and can lead to damage. Similarly, check the fixings to the
ground. Continually check the condition of the structure to ensure that it has not been damaged by the
weather. Damaged parts must be replaced immediately.
Use a mild cleaning solution to clean the roof and rinse it with clean water. Do not use any aggressive agents or
abrasives.
Heavy or abrupt rain can lead to water pockets forming on the roof. These should be removed as soon as
possible. Do not leave the product unattended for long periods of time.
Exposure to sunlight can cause the color of the fabric to fade. This has no effect on the usability of the
product and is not considered a product defect.
If you need spare parts, please contact your dealer.
STORAGE (ESPECIALLY FOR WINTER)
If storage is required, store the dried parts in a dry, well-ventilated place. Do not place any other objects on
the fabric during storage. We recommend storing fasteners in a drawstring bag to prevent small parts from
being lost in handling. Keep away from children.
MATERIAL CARE GUIDELINES
ALUMINUM
Just keep parts made of aluminum clean with common non-aggressive cleaning agents such as mild
detergents, etc.
WOOD
Parts made of wood require some care and attention over its lifetime to ensure a long-lasting beautiful finish.
Proper cleaning and maintenance will keep your wood products looking beautiful for a long time.
Please follow these guidelines to maintain your wood surfaces.
Fading and weathering: Wood is a natural product and is expected to change over time. Long periods of
sun exposure can naturally lead to color fading. Weather extremes, temperature fluctuations, and humidity
highs/lows cause wood to expand and contract, possibly leading to warping and cracking. Knots and small
surface cracks are naturally occurring and do not affect the strength of the product.
Keeping dry: Prolonged moisture and high or low humidity can be harmful for wood. Cracking or splitting
from extremes outside of the normal humidity range of 35-65% are not covered by our warranty.
Preventing prolonged exposure to moisture is advisable.
Cleaning: Frequent light cleaning is recommended. Dust regularly using a slightly damp soft cloth, and then
wipe dry (following the direction of the wood grain). For more thorough cleaning, use a soft cloth and a gentle
soap solution (dilute ¼ cup mild dishwashing liquid soap with 1 gallon of warm water). Rinse with water, and
then immediately dry the surfaces using a soft cloth. Do not use bleach, acid, or other solvents on any metal