Pioneer PDK-FS04 Bedienungsanleitung Seite 13

7
Fix it with the screws (M4 x 10 mm: black) (2
locations: left and right).
Be sure to use the screws to fix the glass panel into
place. Note that failing to do so could cause the
glass panel to fall off if you come into contact with
Caution
it and result in the panel breaking.
8
What to do when attaching an upright media
receiver.
1 Fit the MR holder over the sides of the media receiver and
fix into place using the four screws (M4 x 12 mm) provided
for use in attaching the receiver to the receiver stand.
Note
The legs of the MR holder are on the side of the holder
with the indentations. Be sure to attach the holder in the
correct direction.
Do not attach the MR holder to anything other than a
media receiver.
MR holder
Indentations
Media
receiver
Support
column
Philips screwdriver
Base
9
Screws (M4 x 12
mm) for use in
attaching the
receiver to the
receiver stand.
10
Installation and assembly instructions
2 Fit the legs of the MR holder into the slit of the PDP
bracket, slide down at an angle, and fix into place with
screws (M4 x 10mm).
Note
Do not attach any other equipment other than a media
receiver in this location.
Never place vases, dehumidifiers, or any other objects or
devices with liquids in them on top of the PDP bracket.
Legs of
the MR
holder
Fit into slit and slide
down at an angle.
Screw
(M4 x 10 mm)
Place equipment onto glass panel and connect
equipment to display.
Place the equipment to be connected to the display onto
the glass panel and then connect the equipment to the
display.
Note that the glass panel and base are designed to be able
to withstand loads of up to only 20 kilograms (44.1 lbs), and
that the weight of the equipment placed onto the glass
panel should never exceed this limit.
Note
When a video deck is placed on the glass panel, there may be
times when the video deck interferes with the plasma display
and causes distortion in the picture depending on the place of
the video deck or on other conditions. If this happens, place the
video deck on the base instead to avoid interference.
Attach cable cover.
Fit the cable cover into the center support column.
Note
Be careful when doing so not to allow cables to get caught
between the cable cover and the cable insertion slots.
Cable cover
Slit
13
En