Polar DM071 Bedienungsanleitung Seite 6

EN
Model information can be found on the product database:
https://eprel.ec.europa.eu/screen/product/refrigeratingappliancesdirectsalesfunction
Model information can be found on the product:
The Model Identifier can usually be found on the inside wall and on the reverse of the unit.
Note: Polar offers a 2 year minimum warranty, please contact the authorised representative for more
details.
Cleaning, Care & Maintenance
• Always switch off and disconnect the power supply before cleaning.
• Warm, soapy water is recommended for cleaning. Cleaning agents may leave harmful residues.
• Periodically clean the bottom of the cooler compartment to remove any build-up of condensation.
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source
will also increase the amount of ice and internal/external condensation. If external
condensation occurs wipe the surface down with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and
increase the deterioration of components.
If the gasket or seal is damaged or deformed, energy consumption will increase. To restore
efficiency, replace gasket.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
Appliance is noisy or
works intermittently
Cooler cabinet is not
cold enough
Doors will not close
properly
6
DM071_ML_A5_v6_20230310.indb 6 DM071_ML_A5_v6_20230310.indb 6
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Appliance is not level
Temperature set incorrectly
External environment may require
colder temperature
The door is opened too often
Door seal is worn
Cooler is not level
Door has been reversed and not
properly fitted
Shelves are out of position
Door seal is dirty
Solution
Check the unit is plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Adjust the feet to level the appliance
Check temperature and reset if necessary
Check temperature and reset if necessary
Only open when necessary
Consult a qualified Technician
Adjust the feet
See "Reversing the Door"
Check all shelves are properly inserted
Wipe clean with a damp cloth
2023/3/10 15:50 2023/3/10 15:50