urmet 1068/002 Bedienungsanleitung Seite 3

CONNECTION
The board can be connected to an output power supply of the 1068 series control panels or an additional
power supply Ref. 1067/092.
The connection with the IP interface Ref.1068/013 inside the control panels must be made exclusively by
means of the supplied cable (Length = 50cm), which must be positioned as shown in Figure 3 (A - B).
The PoE devices (e.g. Ref.1068/027), must be connected using the ETH1-POE port as in Figure 3 (C).
The maximum distance depends on the cross-section area of the wire and the power consumption of the
board.
When calculating the overall system consumption, take the maximum consumption of the board and of the
PoE device connected to it into account.
MAIN PARTS DESCRIPTION
DS1068-039A
Ref.1068/013
Fig. 3
KEY
A ETH Interface Ref.1068/013
Cable for connection between
B ETH4
Ref. 1068/002 and Ref. 1068/013
Cable
C ETH1-POE
connection Ref. 1068/027
KEY
+ Positive power supply (13.8 V
A
- Negative power supply (Gnd)
B PWR LED power present
LED logical power present
C +3V5
(+3.5V
D TAMPER Terminal for tamper protection
E ------ Holes for fastening
F ETH2,3,4 RJ45 Ethernet connectors
G ETH1-POE RJ45 POE Ethernet connector
H POE POE status LED
for keypad monitor
)
⎓
)
⎓
3