Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
GENERAL DESCRIPTION
The interface Ref.1068/002 is a Ethernet board with 4 switch ports, one of which is PoE (Power on
Ethernet) capable of supplying power to a PoE device. The board is connected to the power supply
provided by the control panel and therefore can operate even in the absence of mains power.
WARNING! In this document there are only present some essential indications about product. For further
and more detailed information, refer to manuals concerning 1068 series control panels.
INSTALLATION / ASSEMBLY
Proceed as follows to mount the interface inside the 1068 series control panels:
1.
Remove the motherboard.
2.
Insert the Ref.1068/002 in the space provided and fix it to the bottom in the holes provided (C) using
the 4 screws (A) inserted in the supplied spacers (B) (Fig.1).
3.
Connect the cable supplied with Ref.1068/002 to connect it to Ref.1068/013 positioning it as shown
Figure 3 (A – B).
4.
Refit the motherboard.
5.
Insert board 1068/013 by connecting the cable leading out of interface Ref.1068/002.
Additionally, the interface can be inserted:
in wall boxes Ref.1067/017 (Fig.2).
in distribution boxes or similar containers.
NOTE: Use the external antenna (e.g. Ref.1067/014) if the Ref.1068/002 interface is inserted into the
housing provided inside the control panel for optimum signal reception.
WARNING! The connection of the IP PoE interface must be made with the control panel not
powered (lines and batteries disconnected).
Remove the column
if ETH4 is used
2
Fig.1 – Housing in plastic box
Fig. 2 - Housing inside the box Ref. 1067/017
Ref.1068/013
Motherboard
Ref.1068/002
DS1068-039A
Werbung
