Replacing The Lamp; Closing The Door; Technical Data; Installation - Fust NOVAMATIC KS 162-IB Benutzerinformation

Problem
The temperature in the
refrigerator is too high.

Replacing the lamp

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

TECHNICAL DATA

Dimension
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Possible cause
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
1. Disconnect the mains plug from the
2. Remove the screw from the lamp cov-
3. Remove the lamp cover (refer to the il-
4. Replace the used lamp with a new
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
8. Open the door. Make sure that the
Height
Width
Depth
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
mains socket.
er.
lustration).
lamp of the same power and specifical-
ly designed for household appliances.
(the maximum power is shown on the
lamp cover).
socket.
lamp comes on.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
850 mm
595 mm
635 mm
230 V
50 Hz
Positioning
This appliance can be installed in a dry, well
ventilated indoor, also in a garage or cellar,
but for optimum performance install this ap-
41
Solution