Digital Hookups; Setting The Digital In/Out - Sony DPS-V77 Bedienungsanleitung

Digital Hookups

By taking advantage of the DPS-V77's DIGITAL I/O connectors, you can make digital recordings on DAT recorders, input
digital signals from CD, and make digital connections to mixers (see page 29).
Key Board
CD Player

Setting the Digital IN/OUT

To obtain the best possible sound quality when using the
DIGITAL I/O jack, we recommend setting the input mode to
digital, instead of both (digital and analog).
The following steps show you how to set the input mode, adjust
the digital input level, and select the "de–emphasis" mode.
Refer to "Understanding the Signal flow on page 8 for details
regarding the digital signal flow. Also, see "Input Settings and the
Input Signal" and "Digital I/O Terminal Chart" on page 29 for
additional information.
1
Press SYSTEM.
2
Press FUNCTION A to choose "Set Up."
System :
M
Set Memry Pedal
UP
A B C
3
Press FUNCTION A to choose "Input."
System : Setup
Input Gate Bypass
A B C
4
Press FUNCTION A [Mode] and use the
operation dial to select "DIGTL" (digital).
System : Digital I/O
Input Mode:
DIGTL STREO 12.0
Mode ChSel Att 1
A B C
ANALOG IN DIGITAL OUT
DPS-V77 DIGITAL IN
M I D I Morph
D E F
FX
DISP Clock Dry off
D E F
12.0 Auto
Att 2 EMPHA
D E F
DIGITAL IN DIGITAL OUT
DPS-V77
You can select analog (ANALG), digital (DIGTL), or
both analog and digital (Both) jacks for input and
output.
5
Press FUNCTION B [ChSel] and use the
operation dial to select the input
channel(s).
To use both CH1 and CH2, choose stereo (STREO).
To use only CH1, choose monaural 1 (MONO 1).
To use only CH2, choose monaural 2 (MONO 2).
These setting can also be made when using the analog
inputs.
6
Press FUNCTION C [Att 1] or D [Att 2] and
use the operation dial to adjust the digital
input levels.
[Att 1] lets you adjust the digital input level for CH 1.
[Att 2] lets you adjust the digital input level for CH 2.
Press FUNCTION C or D twice to link the parameters
and adjust both digital input levels at the same time.
See pages 9 and 10 for details regarding the input level.
7
Press FUNCTION E [EMPHA] and use the
operation dial to select the de-emphasis
mode.
"Auto" activates de-emphasis automatically according
to the type of digital signal being input.
"On" de-emphasizes all signals input through the
DIGITAL I/O jack.
"Off" turns de-emphasis off and does not alter signals
input through the DIGITAL I/O jack.
See page 10 for details on the emphasis function.
Note
This unit's digital input only accepts signals with either 44.1 kHz
or 48 kHz sampling frequencies. It cannot be used with 32 kHz
signals.
DIGITAL IN
DAT Recorder (mixer, etc...)
13
EN