Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
17. INSTALLATION INSTRUCTIONS
Comply with safety distance between hob and hood.
12.
Mark the 2 drilling holes through the 2 holes
13.
Remove the hood from the bracker
14.
Drill two 8mm holes for the hood locking screws at the marked points on the wall.
B3
B10
15.
Hang the cooker hood on the suspension plate B3
through the 2 holes B15
16.
Fix
the exhaust hose B12 on the nozzle 10
according to B13
or B14.
17.
Slide
the chimney shafts B6 & B8
carefully, that the external (lower) chimney shaft hangs on the mounting bracket B4
picture B5.
18.
Slide the internal chimney shaft B8 up and fix it on the mounting bracket B7
described in picture B9.
19.
Connect the product cable to the power supply and assemble the metal filter.
According to the specific situation the assembly procedure might proceed differently.
Fitting the V-flaps:
• First install half part
B10
• Pins
3
must be top oriented.
• Insert the axle
4
in the hole
the nozzle
B10
Repeat all operations for
•
the assembly of the half part
fi180516TNM
Installation- & User's Instruction
B3
and put it aside.
B8
B6
B15
on the wall, so that the hood can not accidentally be removed from the wall.
and to its final position at the other end of the hose
one inside the other and put them on the cooker hood. Then check
1
in the nozzle
5
on
2
Chimney cooker hoods
B15
on the backside of the cooker hood with a pencil.
B7
B4
B12
again and secure it well by fixing the screws
B10
5
14
Figures are for illustration purposes only
(See chapter 11.1)
B9
B5
B9
as described in
with 2 screws as
2
4
3
1
GB
B13
B14
Werbung
