Herunterladen Diese Seite drucken

Vlano EOS 600 IX Installations & Bedienungsanleitung Seite 28

Kamin dunstabzugshaube

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

English
17. INSTALLATION INSTRUCTIONS
Comply with safety distance between hob and hood.
(A) Air recirculation mode
(B) Exhaust air mode
Attention!
Install carbon filter C
air mode.
A Installation for circulating air filter mode
Same procedure as described under the following
chapter B. However, omit step 16.
In addition fit the carbon filters C
the grease filter.
B Installation for exhaust air mode
Before starting the installation, please remove the 
1.
By using the bracket
holes site on the right height on the wall and
then drill thre 8mm holes at the marked
positions and set the wall plugs.
2.
Fix the bracket
B3
with
3 screws on the wall.
3.
Assemble the one‐way 
valve flaps B11 on the
hood body above the
exhaust nozzle B10.
        The wall plugs supplied with the appliance are for solid masonry only.
B10
4.
Hang the hood on the bracket B3.
5.
Hang the mounting bracket B4
like in picture B5.
6.
Put on the external part of the chimney shaft B6 with the assembled mounting bracket B4
7.
Push the assembled mounting bracket B4
the wall with a pencil.
8.
Remove the chimney
aside. 
9.
Drill 2 holes on the wall using the 2 circles marked before as reference and insert 2 wall plugs in the
holes.
10.
Fix the mounting bracket B4 for the external (lower) chimney shaft with 2 screws on the wall using the 
2 wall plugs.
11.
Fix the mounting bracket B7 for the internal chimney shaft B8
fi180516TNM
Installation- & User's Instruction
only with circulating 
before mounting 
B3
mark the foreseen
B3
Assembly of the V-flaps
Assemble the two half pieces one after the other.
Detailed instructions can be found on the last page of this manual.
B11
up on the upper end of the external (lower) part of the chimney shaft 
against the wall and through the 2 holes mark 2 circles on 
shaft from the cooker hood, hang out the mounting bracket B4
Chimney cooker hoods
(See chapter 11.1)
A
Min. 650mm
B8
B6
B11
B15
high on the wall.
13
Figures are for illustration purposes only
GB
B
C
B7
B5
B4
B9
B11
B10
B15
on the hood.
from it and put

Werbung

loading

Diese Anleitung auch für:

Thea 600 ixThea 600 sensor