TREVIDEA G3FERRARI PTC910 Bedienungsanleitung Seite 12

complete cooling of each part of the unit.
- Before each use, unroll the power cord completely.
- Do not insert anything in the protective grid. Not to
obstruct it and place the unit half a meter from the
surrounding objects. Pay attention: the protection grid
becomes very hot during use.
- Place the unit on solid and stable surfaces. During use,
place leave at least half a meter on each side of the unit.
- Do not use the unit near steam or water (sink, shower,
toilet ...). Do not use as a shelf support for objects.
- Do not cover for any reason, subject to overheating.
- Do not use in rooms smaller than 4 square meters.
The product is equipped with an automatic switch-off that
comes into play in case of overheating. If the product fails
during use, check that the ventilation openings are not
blocked, unplug the unit and allow to cool down for 15
minutes before operating.
WARNING: Do not use this heater in small rooms
when they are occupied by persons not capable of
leaving the room on their own, unless constant
supervision is provided.
The appliance must not be placed immediately below a
power outlet.
1. Working light
5. Air outlet grid
CONTROL KNOBS
Turning the temperature control knob (4) clockwise increases the temperature to be reached before shutting
down the heater. The function selection knob (3) has the following modes:
"O" means the product is off
"I": low heating power (600W)
OPERATING
Install the product as described in the safety information paragraph. Turn the function control knob (3) to the
desired position. Turn the temperature knob (4) clockwise until it stops. At this point the heater starts running
and the working lamp (1) lights up.
ADJUSTING THE TEMPERATURE
Operate the unit by using the temperature control knob (4) set to high (II) until it reaches the desired
DESCRIPTION G60031
2. Handle 3. Function control knob
6. Main body 7. Resting base
"II": highest heating power (1200W)
: Fan function
4. Temperature control knob
11