Werbung
Verfügbare Sprachen
Verfügbare Sprachen
HOW
TO ASSEMB
1. Remove the packing material
Remove
the
packing
material
(styrofoam)
attached to both sides of the cabinet.
2. Install the turntable platter and the turntable
mat
Insert
the
turntable
platter
onto
the
motor
shaft.
3. Attaching counterweight
Push
in the counterweight at the rear end of
tonearm, While pushing the counterweight, turn
it in the arrow direction. After attaching, make
sure that it moves back and forth by turning it.
Note:
Be careful
not to scratch the magnetic
coating
on
the
inner
surface
of
the
turntable.
Further,
avoid
touching
the
diamond-cut (shiny) edge of the turntable
platter with hands, as this may cause cor-
rosion of the surface.
HOW
TO CONNEC
Diamond-cut
edge
1. Connect the left (L) and the right (R) output
wires to the respective "PHONO"
input termi-
nals of the amplifier to be used.
Further,
connect
the ground
wire
(which
is
together with the output wires) to the "GND"
terminal of the amplifier.
Note:
As the supplied
DL-65
cartridge
is of
the MM
(moving magnet) type, be sure
to connect the output wires of the turn-
table to the "PHONO"
input terminals
for MM type cartridges.
U.S. & Canadian models do not include car-
tridge. See page 8 for mounting cartridge.
2. Connect the AC power plug to an AC wall out-
let.
==
Output cord
|
|
Power cord
I
I
'Amplifier
4 AC wall outlet
Ltd
I
1
w
Ac OUTLET
Ground wire
Werbung
