D-Link DHP-200 Bedienungsanleitung Seite 13

The Lower panel contains a history of all remote devices seen on the computer over
a certain period of time. All devices that were on the powerline network are listed
here along with a few other parameters. Devices that are active on the current logical
network will show a transfer rate in the Rate column; devices on other networks, or
devices that may no longer exist are shown with a "?" in the Rate column. The following
remote device information is available from the diagnostics screen:
-Operating System Platform/Version
-Host Network Name
-User Name
-MAC Address of all NICs (Network interface card) connected to the host
-Identify versions of all Driver DLLs and Libraries used (NDIS) and optionally
-HomePlug chipset manufacturer name (Turbo Only devices)
-MAC Firmware Version (Turbo Only devices)
-MAC addresses of all devices connected locally to the host
-Version of the Configuration Utility
-Vendor name
The Lower panel contains a history of all remote devices seen on the computer over
a certain period of time. All devices that were on the powerline network are listed
here along with a few other parameters. Devices that are active on the current logical
network will show a transfer rate in the Rate column; devices on other networks, or
devices that may no longer exist are shown with a "?" in the Rate column. The following
remote device information is available from the diagnostics screen:
All of the above changes can be made
without requiring a recompile.
You have now completed the installation for you DHP-200. Please be sure to
configure all other PowerLine devices on your network to use the same password,
in order for them to communicate with each other.
13