Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Exploded parts diagram
Fig.: Parts List
1. lid
of
the
housing
2. hose connection ½"
3. O ring
4. rubber bearing (2 pcs.)
5. ceramic shaft
5. Mounting:
The pump may only be installed submerged. The maximum
submergence is 1 m. However, it is not self priming and has to
be installed below the water surface level. If used as a power head
pump, we recommend to remove the hose connection (13) on the
suction side and fit the filter basket (11). Please take care that the
pump does not run dry.
The base plate (20) with the rubber suckers (19) can be fitted to the pump
on 3 sides so the outlet position can be adjusted.
After setting up the pump, ensure you can always reach the power plug.
pump
6.
7.
8.
9.
10. filter sponge
washers (2 pcs.)
rotor / magnet
O ring
motor housing
11. bayonet lock
12. filter basket
13. holding plate
14. rubber sucker (4 pcs.)
15. lid of the filter basket
7
Werbung
