JBM 60022 Bedienungsanleitung Seite 9

REF. 60022
2. Pull the locking pin out, the saw head can be now
be fully raised up.
NOTE! The saw head is always locked in the down
position and should remain as such while not in use.
Miter angle adjustment
The miter angle of the blade can be set between 0º and
45º at left- and right-hand positions. It has a main scale
of 0º, 15º, 30º and 45º, but can be adjusted between
small scales:
1. Lift the miter locking trigger to unlock the miter an-
gle.
2. Press the miter latch while moving the turntable
simultaneously.
3. Place the blade into the desired angle.
4. Release the miter latch, the blade should snap in
position.
5. Place the locking trigger to its original position to
secure it in place.
90º (0º) miter pointer adjustment
1. Place the table to the 0º positive stop.
2. Loosen the miter pointer locking screw.
3. Adjust the pointer and retighten the screw.
Cutting depth adjustment
You can adjust the cutting depth for
even and repetitive shallow cuts:
1. Place the cutting head down to
the desired teeth blade depth.
2. While holding the upper arm in
that position, turn the stop knob
until it touches the stop plate.
3. Check the blade depth by mo-
ving the cutting head front to
back.
Bevel angle adjustment
The bevel angle can be set from 0º to 45º to the left:
1. Loosen the bevel locking knob.
2. Adjust the bevel angle according to the scale.
3. Tighten the locking knob to secure it in position.
0º (90º) bevel stop adjustment
1. Loosen the bevel locking knob and move the cut-
ting head fully to the right.
2. Tighten the bevel locking knob.
3. Place a flat engineers square against the table
and the flat side of the blade.
4. Check whether the table and blade form a 90º
angle.
If it is not the case:
1. Loosen the bevel locking knob and move the cut-
ting head back to the left.
2. Loosen the locking nut and rotate the 90º bevel
adjustment stop in or out using a spanner until ge-
tting a 90º angle.
3. Tighten the 90º bevel adjustment stop locking nut
and the bevel locking knob.
45º bevel stop adjustment
1. Loosen the bevel locking knob and move the cut-
ting head fully to the left.
2. Tighten the bevel locking knob.
3. Check whether the blade is 45º to the miter table
with a combination square.
If it is not the case:
1. Loosen the bevel locking knob and move the cut-
ting head to the right.
2. Loosen the locking nut and rotate the 45º bevel
adjustment stop in or out to set the correct angle.
· 9 ·