IKEA TRETAKT plug smart Bedienungsanleitung Seite 5

Factory reset your smart plug:
Push the reset button on top of the smart
plug with a pointy object for at least 5
seconds until the LED starts pulsating.
IMPORTANT!
• The Smart plug is for indoor use only
and can be used in temperatures from
0ºC to 35ºC.
• Do not leave the Smart plug in direct
sunlight or near any heat source, as it
may overheat.
• Do not subject the Smart plug to wet,
moist or excessively dusty environments
as this may cause damage.
• The range between the steering device
and the receiver are measured in open
air. Different building materials and
placement of the units can affect the
wireless connectivity range.
WARNING:
• Do not connect after each other in
sequence.
• Do not cover when in use.
• To disconnect the power, pull the plug.
• Use only indoors in dry areas.
• Do not overload the product.
• Discard the product if damaged.
• For adult use only. This is not a toy and
is not intended for use by children.
Care instructions
To clean the Smart Plug wipe with a soft
dry cloth.
Note!
Never use abrasive cleaners or chemical
solvents as this can damage the product.
Product servicing
Do not attempt to repair this product
yourself, as opening or removing covers
may expose you to dangerous voltage
points or other risks.
Save these instructions for future use.
Technical data
Model: TRETAKT plug smart
Type: E2209
Input: 230V, 50/60Hz
Max output power: 3680 W
Resistive load/ Max 300W motor load
Range: 10 m in open air.
For indoor use only
Operating frequency: 2405-2480 MHz
Output power: 10 dBm
5