Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USING THE DETERGENT
B
A
30
20
SETTING AND STARTING A
PROGRAMME
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• The display shows two horizontal sta-
tus bars.
If the control panel shows other condi-
tions, press RESET until the appliance is
in setting mode.
Starting a programme without
delay start
1. Open the water tap.
1. Press the release button (B) to
A
open the lid (C).
+
-
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
C
phase, put a small quantity of de-
tergent on the inner part of the ap-
pliance door.
4. If you use detergent tablets, put
the tablet in the compartment (A).
5. Close the lid. Make sure that the
release button locks into position.
2. Press the on/off button to activate
3. Set the programme.
4. If you want, you can set the options.
5. Close the appliance door. The pro-
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
CAUTION!
Use only detergents for dish-
washers.
Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
the appliance. Make sure that the
appliance is in setting mode.
• The related programme number
flashes in the display.
gramme starts.
• If you open the door, the display
shows the programme duration
that decreases with steps of 1 mi-
nute.
again until the display shows the de-
ENGLISH
35
Werbung
