Panasonic TX-42MZW984 Bedienungsanleitung Seite 12

Indicator / Control panel
When pressing 4, 5, 6 buttons, the control panel guide
≥
appears on the right side of the screen for 3 seconds
to highlight which button has been pressed.
1 2 3
Rear side of the TV
1 Remote control signal receiver (for infrared
communication)
Do not place any objects between the TV remote
≥
control signal receiver and remote control.
2 Ambient sensor
Senses ambient lighting conditions to adjust the
≥
picture when [Auto Brightness] and [Auto White
Balance] (Picture > Ambient Sensor Settings) are
set to [On].
3 Power LED
Red:
Standby
Green:
On
• Depending on the ambient brightness, adjusts
the brightness of LED to easy-to-view levels
automatically.
Orange:
Standby with some functions (recording, etc.)
active or panel maintenance in progress
≥ The LED blinks when an infrared signal is received
from the remote control.
4 Input mode selection
Press repeatedly until you reach the desired mode.
≥
Menu
Press and hold for about 3 seconds to display the
≥
menu bar.
OK (when in the menu system)
12
English
4
5
8
6
7
5 Channel Up / Down
Cursor Up / Down (when in the menu system)
≥
6 Volume Up / Down
Cursor Left / Right (when in the menu system)
≥
7 Power On / Off switch
Switches TV On or Off (Standby)
≥
To turn Off the apparatus completely, you must pull
≥
the mains plug out of the mains socket.
[ ]: Standby / On
≥
8 Model name plate
Panel maintenance
Be sure to turn the TV off with the remote control or
Power On / Off switch to perform the panel maintenance.
The panel maintenance automatically starts, and it takes
approx. 10 minutes. During the panel maintenance, LED
turns to orange. The maintenance works as necessary.
During panel maintenance, avoid touching and
≥
exerting any pressure on the screen. (e.g. wiping the
screen, etc.)
First time Auto Setup
When the TV is turned on for the first time, it will
automatically search for available TV channels and give
options to set up the TV.
These steps are not necessary if the setup has been
≥
completed by your local dealer.
Please complete connections (p. 8 - 9) and settings (if
≥
necessary) of the connected equipment before
starting Auto Setup. For information about the settings
for the connected equipment, read the manual of the
equipment.
1
Plug the TV into a live mains socket and
turn the power on
Takes a few seconds to be displayed.
≥
2
Select the following items
Set up each item by following the on-screen instructions.
Example:
Please select your viewing environment.
Home Shop