Sandri Garden SG-FP SNAP LITIO Gebrauchsanweisung Seite 23

h) Do not let familiarity gained from frequent use of tools allow you to become
complacent and ignore tool safety principles. A careless action can cause severe injury
within a fraction of a second.
4) Power tool use and care
a) Do not force the power tool. Use the correct power tool for your application. The
correct power tool will do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn it on and off. Any power tool
that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool's
operation. If damaged, have the power tool repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be performed.
Use of the power tool for operations different from those intended could result in a
hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for safe handling and control of the tool in
unexpected situations.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
CONSUMABLES
These pruning shears are compatible with the following accessories:
Cod. 70330-25
70330-81 BLADE
70330-82 COUNTER-BLADE N. 8
70330-83 BATTERY
93525-90 BLADE BOLT N. 10
93525-91 SWITCH LEVER N. 12
93525-92 ELECTRIC BOARD N. 25
Instructions for disposal
The bin symbol (on the packaging and/or product) indicates that the article is classified
as EEE
N. 6
Cod. 70330-35
70330-83 BATTERY
70330-85 BLADE
70330-86 COUNTER-BLADE N. 8
93525-95 BLADE BOLT N. 10
93525-96 SWITCH LEVER N. 12
93525-97 ELECTRIC BOARD N. 25
20
N. 6
EN