Sandri Garden SG-FP SNAP LITIO Gebrauchsanweisung Seite 17

6. During normal cutting operations press the trigger to close the blades and
release it to open them.
Cutting adjustment
code 70330-25 SG-FP SNAP: after holding the trigger down for approx. 3 seconds, a
BEEP is heard: by releasing the trigger after the BEEP, the cutting width varies
compared to the previous one (the blades move apart or closer together); if the trigger
is not released after the first BEEP, the cutting width returns to the one before the
opening.
code 70330-35 SG-FP 32: either by releasing the trigger after the first BEEP or by
waiting for the next BEEP, the cutting width changes back to the previous one (the
blades move apart or closer together).
End of work
Closing the blades: by holding down the trigger, an acoustic signal will be heard to
indicate automatic closing of the blades.
Stand-by mode
code 70330-25 SG-FP SNAP:
will automatically enter "standby" mode. After 2 minutes of standby time, the
machine automatically enters "sleep/stop" mode.
code 70330-35 SG-FP 32:
to enter "Standby" mode.
Important: Use the device correctly, carefully following all instructions. Do not use the
device if it, the battery and/or charger are damaged.
CHARGING THE BATTERY
It is recommended to charge the battery before the first use of the secateurs.
- Insert the charger cable into the charging hole on the battery, then insert the charger
plug into the wall socket.
- The LED light on the battery is red while the battery is charging and turns green when
the battery is fully charged.
- The battery takes about 1.5-2 hours to reach full charge.
- When the battery is fully charged, the scissor can work continuously for about 3-4
hours.
Caution:
Hold the trigger for 3-5 seconds and the machine
Hold the trigger for 3 seconds or let it sit for 1 minute
14
EN