Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT : This instruction manual includes essential information on the safety measures to be
implemented for installation and start -up. It is important to read these instructions before beginning
installation and start-up. Keep this manual for future reference .
Failure to comply with the instructions given by the manufacturer in this manual regarding
installation, operational start up and mainten ance of the product exonerates the manufacturer or the
distributor from any liability for damages affecting persons, the concerned product or the other
installations, and shall void the guarantee .
1. VERIFY THE CONTENT OF THE PACKING
~12V LED projector with 2 meters of 2x1,5 mm² HO7RNF cable
Bag with cork to be screwed, gland, silicone gasket for cable and 2 black circular
gaskets
Radio remote controller 4 buttons with battery
Installation kit
Manual of installation and maintenance
2. GENERAL CHARACTERISTICS
This projector has been designed to be used immerged in fresh water. It is a Class III electric
apparatus with very low safety voltage ~12V.
This projector complies with IP68 degree of protection at a nominal immersion depth of 1 meter.
This projector complies with international standards for lights, especially the EN 60598-2-18
standards, lights for swimming pools and similar applications.
This projector must be connected to a power supply cable with a minimum section of 2x1mm².
3. INSTALLATION
For a correct installation, the power socket which feeds the installation lamp will have to possess a
device of protection by residual current with a maximal intensity of 30 mA.
This projector will be only connected to a ~12V security transformer with double winding. Another type
of transformer is prohibited.
The power of this transformer will be always higher than the power of all projectors connected.
The projector must be placed on the wall of the swimming pool under approximately 400-700 mm of
the surface of the water.
The installation requires a dedicated 1,5' vacuum fitting linked to a 200-300 mm wall crossing, a tube
and a connexion box located upper the water level to guarantee the water proofing of the pond.
The projector cable will cross the vacuum fitting and be connected to the junction box.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any
electric components which have been inserted or handled at locations other than its own premises.
4. ASSEMBLY and REPLACEMENT
Before installing the projector, it is important to provide a 1"1/2 vacuum fitting compatible with the
screwing method.
Be sure that the wall inlet corresponds to the type of pool structure and does not leak. Do not use in
an above ground pool with flexible wall.
The wall inlet must be connected to a junction box by a waterproof conduit.
The cable must pass through the conduit and connect to a ~12V power supply in the junction box.
Before any operation, turn OFF the power supply to the projector
Remove the front cover by unscrewing the 3 screws (Fig.1)
Screw the projector with the back tubular part connected to the power supply cable
At the back of the projector, install the black gasket with the size adapted to the vacuum
fitting model (Fig.2)
Pass the cable through the inlet fitting, and pull it up from the junction box
Do not cut the cable, keep it in the junction box to allow a further replacement of the
projector on a dry place on the edge of the swimming pool
Screw the back tubular part with hand to a complete blockage against the vacuum fitting
Install the front cover and narrow the 3 screws in the U shape of the support
Check the cover stays free of movement with hand action
Connect the cable to the power supply in the junction box using waterproof connectors
Switch the power "ON"
ENGLISH
Werbung
