ACU-RITE IOB 610 Betriebsanleitung Seite 16

Personnel requirement
Maintenance step Interval
Check all labels Annually
and symbols
provided on the
product for reada-
bility
Inspect electrical Annually
connections for
damage and
check their
function
6.4 Resuming operation
When operation is resumed, e.g. when the product is
reinstalled after repair or when it is remounted, the same
measures and personnel requirements apply as for
mounting and installing the product.
Further information: "Mounting", Page 12
Further information: "Installation", Page 13
16
Corrective action
Contact an author-
ized service
agency
Replace defective
cables. Contact an
authorized service
agency if required.
7 What to do if...
7.1 Overview
This chapter describes the causes of faults or malfunctions
of the product and the appropriate corrective actions.
7.2 Malfunctions
If faults or malfunctions that are not listed in the
"Troubleshooting" table below occur during operation, refer
to the machine tool builder's documentation or contact an
authorized service agency.
ACU-RITE | IOB 610 | Operating Instructions | 04/2018