ACU-RITE IOB 610 Betriebsanleitung Seite 12

4 Mounting
4.1 Overview
This chapter contains all of the information necessary for
mounting the product.
The following steps are only to be performed
by qualified personnel.
Further information:
Page 7
4.2 Assembly
General mounting information
Mounting clips are provided on the rear of the product. The
connection is compatible with a standard 35 mm,
DIN EN 50022 rail.
The product must be mounted in a cabinet or
on a mounting stand to ensure the correct and
intended operation of the product.
12
"Personnel qualification",
4.2.1 Mounting on a DIN rail
The product's mounting clips allow you to mount the
product on a standard 35 mm, DIN EN 50022 rail in an
electrical cabinet or on a stand.
Insert the bottom edge of the DIN rail into the bottom
channel of the products mounting clips
Rotate the top of the product towards the DIN rail
Snap the DIN rail into the top channel of the mounting
clips
"B", Page 210
Further information:
ACU-RITE | IOB 610 | Operating Instructions | 04/2018