Panasonic MX950B Bedienungsanleitung Seite 10

Registering the remote control (supplied)
Either Bluetooth wireless technology or the infrared
®
communication function can be used for the
transmissions between the TV and the remote control.
Since voice controls (p. 11) use Bluetooth
technology, the remote control needs to be registered
(paired) with the TV.
When using the remote control for the first time after
≥
purchase, when you press any button while pointing
the remote control at the remote control signal
receiver with batteries inserted, the remote control is
automatically registered (paired).
When registering, face the remote control at the
≥
remote control signal receiver on the TV, within about
50 cm.
≥ Registration may not be completed correctly if the
batteries in the remote control are running low.
∫ If registration fails
If registration (pairing) is not completed properly, try
registering again.
Use the below procedure to select [Pairing]
[Main Menu]
[Remote Control Settings]
The registration screen is displayed, so follow the on-
≥
screen instructions to register.
∫ When the remote control does not respond
1
Press and hold the buttons shown below
simultaneously for about 3 seconds
2
Point the remote control at the remote control signal
receiver and follow the procedure below to deregister
(unpair) the remote control
[Main Menu]
[Remote Control Settings]
3
Register (pair) the remote control again
registration fails" (p. 10)
<Note>
If the remote control is not registered (paired) with the
≥
TV, they communicate via infrared. Face the remote
control at the TV's remote control signal receiver for
operation when infrared communication is used.
Please note that voice controls will not be available.
If the remote control is registered (paired) with the TV,
≥
they communicate via Bluetooth
face the remote control at the TV's remote control
signal receiver when Bluetooth
used. Please note, however, that you will need to face
the remote control at the remote control signal
receiver for operation when turning on or off the TV.
10
English
wireless
®
[Setup] [System Menu]
[Pairing]
[Setup] [System Menu]
[Unpair]
"If
. You will not need to
®
communication is
®
Identifying Controls
Remote Control
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1 [ ]: Switches TV On or Off (Standby)
2 Viewing mode
3 Streaming Service
4 Coloured buttons
(red-green-yellow-blue)
5 MENU
6 HOME
7 Information
8 OK
9 Option menu
10 PROVIDER/LIST
11 Voice control
12 Sound Mute On / Off
13 Volume Up / Down
14 Numeric buttons
15 [eHELP]
16 Microphone
17 Input mode selection
18 Applications list
19 TV Guide
16
17
18
19
20
21
22
23
24
25
26
27
28