Herunterladen Diese Seite drucken

Active ST32 Benutzerhandbuch Seite 28

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 46
ENGLISH
REFUELING
WARNING: Refueling must be carried out with the engine switched off. Slowly
unscrew the tank cap to allow any excess pressure to escape.
Tighten the tank cap correctly after refuelling. Move the brushcutter at least
3 m away from the refuelling point before starting the engine. Thoroughly
clean around the tank cap before refuelling. Dirt inside the tank causes
engine malfunctions. Ensure that the mixture is homogeneous by shaking
the canister or tank.
START THE ENGINE
Place the brushcutter on a flat, clear surface and check that the cutting tool
is free to rotate. Set the switch to position(1)Fig. 17. Press the bulb (C) 5 or
6 times Fig. 19. Move the choke lever(C)to close position(A)Fig.18. Hold the
brushcutter stationary and pull the starter lever (C) back to the original open
position(B) Fig. 18. Repeat the starting manoeuvre until the engine starts.
With the engine running, press the throttle(2)Fig. 17 to release it from the
automatic half throttle position and bring the engine to idling speed.
WARNING: When the engine is already hot, do not press the bulb(C)Fig.19
and do not use the starter for starting. Do not suddenly release the starter
rope, this could damage the starter unit.
STOP THE ENGINE
Move the throttle lever(2)Fig.17 to the idle position and wait a few seconds
to allow the engine to cool down. Move the ground switch to the stop
position(0)Fig. 17.
WARNING: When the engine is idling (2600 ~ 3000 rpm) the cutting
tool must not rotate. If the idle speed is too high, unscrew the screw
(H)Fig. 3 anticlockwise.
WARNING: After intensive use of the machine do not suddenly
switch off the engine but let it idle for a few minutes to stabilise it.
Mufflers fitted with catalytic converters become very hot during
use and remain so for a long time after the engine has stopped.
This happens even when the engine is idling. Contact can cause
skin burns.
Never add fuel to a machine when the engine is running or hot.
FIRE HAZARD.
Move at least 3 metres away from the refuelling position before
starting the engine. DO NOT SMOKE!
28
ST32 - ST37

Werbung

loading

Verwandte Produkte für Active ST32