GardePro E6P MAX Bedienungsanleitung Seite 27

Using the adjustable strap: To use the strap on the camera,
push one end of the strap through the two brackets on the back
of the camera. Thread the end of the strap through the buckle.
Fasten the strap securely around the tree trunk by pulling the
end of the strap firmly so there is no slack left (Figure 17).
Using the tripod socket: The camera is equipped with a socket
at the bottom end to enable mounting on a tripod or other
mounting accessories with a standard UNC 1/4-20 thread screw
(not included).
9.2. Sensing Angle and Distance Test
To test whether the camera can effectively monitor the area
you choose, this test is recommended to check the sensing
angle and monitoring distance of the camera. To perform the
test:
Switch the camera to the ON mode.

Press MENU button, go to "Motion Test". The camera

will count down a max 60-second delay and be ready to
capture motion. (Note: The delay time may be less than 60
seconds, depending on the actual time of the motion
sensor to be activated. The delay time is 60 seconds minus
Figure 17: Mounting the Camera
23