Nils Extreme HM2140 Gebrauchsanleitung Seite 6

ASSEMBLY:
No tools are required. The scooter reaches the customer assembled. The only thing it requires is unfolding.
1. Pull back the lock as shown in the picture below and unfold the scooter.
Push the handlebar stem until it clicks into place. Then close the locking mechanism.
3. Insert the handles and then place them into the holes on either side of the steering bracket. When each handle is fitted, you will hear
the spring-loaded ball catch (pin) click, indicating that it is fitted correctly. Check that both pins are visible on the outside of the bracket.
Some models have a button lock to further stabilise the handles.
Unlock the steering column lock (lever). Adjust the height by extending the bar until you hear the spring-loaded latch (pin) click,
indicating that the correct steering wheel setting has been achieved. Lock the steering column with the lock. The height of the
handlebar can be set to one of the three heights provided (89cm/96.5cm/103.5cm). Adjust the height to your preference.
Strona 6 z 19