Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Engine Switch
3.
Right Steering Lever
5.
Left Steering Lever
7.
Tipping Handle
9.
11.
Gas Spring Assistance (Optional)
13.
Throttle Control
15.
Gear Selection Lever
The gear selection lever has 4 positions: 3 forward speeds and 1 reverse. To change speeds, move the
speed shift lever to the desired position. The lever locks in a notch at each speed selection.
Always release the clutch control lever before changing speeds. Failure to do so will result in damage
to the power trackbarrow.
Slower speeds are for heavier loads, while faster speeds are for transporting light loads or an empty
hopper. It is recommended that you use a slower speed until you are familiar with the operation of the
power trackbarrow. If the engine slows down under a load or the tracks slip, shift the machine into a lower
gear. If the front of the machine rides up, shift the machine into a lower gear. If the front continues to ride
up, lift up on the handles.
Left/Right Steering Lever
Operate the lever to turn left/right.
Operate the steering levers only at a reduced speed.
Gas Spring Assistance (Optional)
The gas spring assistance provides support when lifting and lowering the hopper.
Engine On/Off Switch
The engine switch has two positions. OFF - engine will not start or run. ON - engine will start and run.
Recoil Starter Handle
The recoil starter handle is used to start the engine.
Fuel Shut-Off Valve
The fuel shut-off has two positions:
CLOSED (
) - Use this position to service, transport, or to store the unit.
OPEN (
) - Use this position to run the unit.
Throttle Control
The throttle control regulates the speed of the engine, and moves between FAST
and STOP positions. The throttle control will shut off the engine when it is moved to the STOP position.
EN
Track
Fuel Shut-Off Valve
2.
Throttle Control
4.
Clutch Control Lever
6.
8.
Gear Selection Lever
10.
12.
Recoil Starter Handle
14.
Choke Control
Hopper
Gearbox
, SLOW
,
Werbung
