Setup Menu; Preparations For Using The Setup Menu; Installing The Device Driver - G&D MultiPower-12 Installationsanleitung

Setup menu

With the setup menu, you can view and change the settings of the
Setup Menu for MultiPower-12
Show Firmware Info
Show Temperature Info
Show Load Info
Show Power Out Info
Set System Defaults
Power Start Delay:
Power Channel Delay:
Left/Right: Toggle
You can operate the setup menu in any terminal emulator (for example HyperTerminal
or PuTTY).

Preparations for using the setup menu

Before calling up the setup menu, you need to install a device driver on the computer
to address the Service socket and establish a connection in the terminal emulator.

Installing the device driver

Before establishing a connection in the terminal emulator, install the device driver
CP210x USB to UART Bridge VCP
The driver provides the Service socket (connected by using the service cable) as vir-
tual serial interface (COM port). You can select the virtual interface in the terminal
emulator to establish a connection.
How to install the device driver to address the Service socket:
1. Open the website www.gdsys.de
2. Go to Downloads > Drivers &Tools
3. Download the device driver
ating system.
4. Execute the file and follow the instructions given in the installation wizard.
.
in a web browser.
.
CP210x USB to UART Bridge VCP
Setup menu
MultiPower-12 .
...
...
...
...
...
0,7 s
0,1 s
S:Save
for the computer's oper-
G&D MultiPower-12 · 6