Status Displays - G&D MultiPower-12 Installationsanleitung

Status displays

Status displays
The Load and Power
back panel of the central power supply show the
device status and the load of active devices.
Section LED
Load
Power Red.
Main
The LED next to each
panel shows the status of the socket.
Section LED
Power Out [x] Status
5 · G&D MultiPower-12
LEDs on the front and the
Status Meaning
The load of the active devices is displayed in an LED scale.
Four green and two yellow LEDs highlight the reaching of
the maximum load.
If the maximum load is exceeded, one or two red LEDs
light up.
Note: If one or two red LEDs indicate that the temperature
within the device is too high, make sure to cool the device.
On The power pack is turned on and supplies the required
voltage.
Off The power pack is turned off, or there is no connection to
the mains.
On The power pack is turned on and supplies the required
voltage.
Off The power pack is turned off, or there is no connection to
the mains.
Power Out socket on the back
Status Meaning
On Voltage available at this output.
Off No voltage available at this output.
In case of an overload or a short circuit, the output is disa-
bled but becomes active after 10 seconds.
Load
Power Status
Power Out 1 Power Out 2 Power Out 3
Power
Red.
Main