Werbung
Verfügbare Sprachen
Verfügbare Sprachen
21055L
Leak testing
To detect a gas leak in a gas line, proceed as follows:
Get closer to the probe of the gas line, insert the probe slowly along the gas line. Repeat
this process on the opposite side of the gas line. If you approach a gas leak, the LED
row will light and the alarm interval sounds shorter. The device requires at least two
minutes, until another measurement process can be made.
Replace battery
If the battery warning light (# 5) for a low battery
status lights, the battery must be replaced with
a new one. Do this, remove the two Phillips
screws on the back, remove the cover and
replace the batteries.
Diagnostics on the device
The unit does not power on
a) Have you pressed the On/Off switch for more than 2 seconds?
b) Check the batteries. Were they the right way used?
c) Replace the batteries with fresh batteries. Please try again.
The probe LED don not light after 60 seconds
a) Check whether the probe has a good contact. Should not change the condition of the
unit, contact your dealer.
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Straße 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
www.swstahl.de
Werbung
