Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Inserting the batteries
After you have unpacked your device, first insert the
batteries. The battery compartment is on the bottom of the
device. Remove the battery cover by sliding it in the direc-
tion shown. Insert the batteries (2 x 1.5 V, size AAA),
thereby observing the indicated polarity.
Replace the batteries when the low power
indicator 5 appears on the display.
Always replace both batteries at the same time.
6. Risk Reminder
If the device detects your pulse rate is lower than 50 bpm,
higher than 130 bpm or the SpO
level is lower than 94%,
2
there will be a warning sound alert.
7. Using the Lanyard
1. Thread the thinner end of the lanyard through the
hanging hole at the rear end of the device.
2. Thread the thicker end of the lanyard through the
threaded end before pulling it tightly.
4
8. Malfunctions and Actions to take
Descrip-
Symptom/Possible
tion
causes
SpO
or
1. Finger is not
2
inserted correctly.
pulse rate
2. Patient SpO
value
do not
2
display
is too low to be
normally.
measured.
3. There is excessive
illumination.
SpO
or
1. Finger might not be
2
inserted deep
pulse rate
enough.
is shown
2. Excessive patient
unstable.
movement.
Descrip-
Symptom/Possible
tion
causes
Solutions
The device
1. No batteries or low
cannot be
powered
2. Batteries are not
1. Retry
on.
inserting the
3. The device may be
finger.
2. & 3. Measure
more times. If
you deter-
mine the
product is
The
1. The device is auto-
working
display
correctly,
suddenly
consult your
switches
doctor.
off.
2. The battery power is
1. Retry
inserting the
finger.
9. Cleaning and disinfecting
2. Sit calmly and
retry.
Use an alcohol swab or cotton tissue moistened with
alcohol (70% Isopropyl) to clean the silicone that touches
the finger inside of the device. Also clean the finger being
tested using alcohol before and after each test. Allow the
device to dry thoroughly before use.
Solutions
1. Replace the
battery power.
batteries.
2. Remove and
installed correctly.
reinstall the
batteries.
damaged.
3. Contact your
local Micro-
life-Customer
Service.
1. Normal.
matically powered
2. Replace the
off, when no signal
batteries.
was detected after 8
seconds.
too low to operate.
Werbung
