O'Clair BLOM200 Bedienungsanleitung Seite 36

TECHNICAL MANUAL. START-UP AND OPERATION
Advanced Operation
Sort Code Parameter Name
F11 Setting temperature
F12 Temperature difference
F13 Max setting temperature
Temperature
F14 Min setting temperature
Auto mode temperature
F17
difference
Evaporator sensor
F18
adjustment
F19 Temp sensor adjustment
F21 Compressor delay time
Compressor controlling
Compressor
F29 mode (temp controlling
F31 Defrost start temperature
F32 Defrost end temperature
F33 Defrost start time
Defrosting
F34 Max defrost time
F37 Defrost mode
How to set the temperature?
How to read the temperature of the evaporator sensor?
Range
F14 – F13
0.1 – 20
-58 - 302
-58 – 302
3 - 20
-20 – 20
-20 – 20
0 -- 10
COOL / HEAT
/C/H
mode)
-20 – 80
0 – 100
1 – 999
Off, 1 – 99
0 - 1
Factory setting Unit
The setting range is limited
28 ℃ / ℉
by F13 and F14
Control the temperature
1.0 ℃ / ℉ difference, please refer to the
temperature controlling
Notice: the controller will
35
℃ / ℉
follow the rule of
F14<F11<F13 forcibly, if
you find out that one
parameter can not be
10
℃ / ℉
adjusted, it is because the
parameter is limited by other
parameters, you must ECO
adjust other parameters
If F17<F12,F17=F12
3
℃ / ℉
admited
Adjust the outdoor machine
0.0
℃ / ℉
sensor bias
Adjust the temperature
0.0 ℃ / ℉
sensor bias
3 min
COOL: refrigeration mode
HEAT - HEAT: Heat mode
C/H :Auto mode
-2 / -1 / 0
℃ / ℉
10 / 20 ℃ / ℉
5 min
10 min Off means no defrost
0:air defrost
0 / 1 -
1: 4 way valve defrost
Remark
Depends on the model
Depends on the model