Tern Physis RF Bedienungsanleitung Seite 5

2
3
All manuals and user guides at all-guides.com
2. Tighten the Headset Bolt to a torque of 6-8 Nm by using a
5 mm Allen wrench. This will pull Fork closer toward Physis
Handlepost.
If Physis Handlepost was completely removed, or if a new
Handlepost is being installed, ensure that the rubber Base
Seal at the bottom of the Handlepost is properly seated before
installing back onto the Fork Steerer.
If steering feels too tight or sticky, loosen the Headset Bolt
slightly until turning is smooth.
3. Check that the Handlebar and Front Wheel are at right angles,
then tighten the Steerer Clamp Bolts to a torque of 10-12 Nm
with a 5 mm Allen wrench.
EN
ES
FR
IT
JP
TC
SC
KO
DE
5