Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Mounting
NOTICE
Damage to the product due to incorrect
assembly.
►Assemble the product completely and
safely.
►Do not use electric screwdrivers during
assembly.
►Do not force the screws into the drill holes.
►Screw the screws into the mounting ho-
les, tighten the screws only in the last
step to prevent the frame parts from
jamming.
4.1 Place of installation
1. Select a suitable installation location that
meets the following requirements:
• The installation location is dry and can be venti-
lated regularly.
• The installation site is not permanently exposed
to the sun and strong temperature fluctuations.
• The subsurface of the installation site is level and
non-slip.
2. Follow the assembly steps shown, observing
the safety instructions, see "15. Assembly" on
page 43.
4.2 Install LED lighting
Note: The adhesive reaches its maximum effect
after approx. 24 hours.
1. Clean the surface of the mirror. It must be free
of grease and dirt
2. Glue the first LED to point 1 or 2, depending on
which side the socket is located. Use the illust-
ration of the lengths below to help you deter-
mine the position of the LED.
3. Pull off the protective foil and press the LED
against the mirror with light pressure for ap-
prox. 30 seconds.
4. If necessary, wrap the individual cable secti-
ons around the individual LEDs to prevent the
cable from dangling loosely.
5. Now glue all further LEDs to the mirror at equal
intervals.
4.3 Fix dressing table to the wall
1. Place the dressing table in the desired position.
2. Hold the corner bracket [L] and mark the drill ho-
les with a pencil.
14
3. Drill the drill hole with a Ø 6 mm drill bit and
clean the drill hole.
4. Carefully press the dowel into the drill hole.
5. Repeat steps 2 - 4 for the other side.
6. Fix the dressing table to the wall using the cor-
ner brackets.
7. Slide the drawer into the drawer holder.
5. Transport
CAUTION
Risk of injury and material damage due to in-
correct transport.
►Disconnect the power supply unit from the
power outlet before transport.
►Only transport the product when it is disas-
sembled and with at least one other per-
son.
►Do not push the product over the ground.
6. Use
WARNING
Risk of electric shock, fire and short circuit.
Damaged cables can cause short circuit,
fire and electric shock.
►Do not kink or crush the power cable.
►The power supply unit must be freely
accessible at all times,
CAUTION
Risk of injury due to improper use.
►Use the product in accordance with its in-
tended use, see chapter "1.2 Use as in-
tended" on page 12.
CAUTION
Risk of tripping.
►Prevent tripping hazards from the pow-
er cable by routing it securely.
NOTICE
Damage to the product due to incorrect
use.
►Make sure that the product is free from
damage before use. Use of a defective
or damaged product is prohibited.
Werbung
