Profeco 77405 Gebrauchsanleitung Seite 24

Adjusting cutting height
To obtain the desired cutting height, the front and rear axles must
be adjusted to the underside of the casing.
Warning! Disconnect the mower from the power supply and check
that the blade has stopped turning before adjusting the height.
1. Adjusting the cutting height of the front wheel (Fig. 2a)
1) Turn the mower upside down.
2) Pull the wheel shaft towards the front of the mower.
3) Set the wheel shaft to the desired cutting height adjustment
position.
Note: Make sure that both the right and left front wheels are in the
same cutting height adjustment position.
2. Setting the cutting height of the rear wheel (Fig. 2b)
1) Turn the mower upside down.
2) Pull the rear wheel axle towards the catcher of the mower.
3) Set the wheel shaft to the desired cutting height adjustment
position.
Note: Make sure that both the right and left front wheels are in the
same cutting height adjustment position.
3. Cutting height positions (Fig.2c)
1) 20mm (Lowest cutting height)
2) 40mm
3) 60mm (Highest cutting height)
24