Hoover 48019757 Bedienungsanleitung Seite 7

IMPORTANT:
1. The appliance has a "Steam Boost" Function. If you want to increase the amount of Steam you can press the
"Steam Boost " Button (15), the green light will illuminate , indicating you have actioned this function.
2. When "Water tank empty" light (14) remain red, this means there is no more water in the tank. Please refill
the tank following the instructions of chapter 1.2.
N.B.
The first time the appliance is used, some fumes, dust and a smell can be noted.
It's quite normal and will quickly disappear.
This is due to a treatment applied to the soleplate that improves the steam performance.
Before use, please use the iron as described in Chapter 2.4 Vertical Steam Ironing.
Chapter 2: Using Your Steam Generator
Chapter 2.1: Regulating the Soleplate Temperature
Select the temperature of the soleplate by turning the dial (12) on the iron to the desired position.
Wait a few moments until the iron light (10) is off.
This indicates that the soleplate has reached the required temperature.
While Ironing , the Iron light may switch on and off, this indicates that the temperature is
being Adjusted automatically to maintain temperature so as not to interrup your ironing.
Help
To know the best suitable temperature for each textile, check the laundry care label of the article to be ironed.
Please note that during use, the temperature light goes on from time to time. It signifies that the iron is heating up
to the set temperature.
When ironing material with mixed fabrics, always ensure the temperature is set to the correct setting.
If you select a lower temperature while ironing, wait until the iron has cooled down to the set temperature before
you continue ironing.
If the temperature is too low, some drops of water could escape from the soleplate. Please raise up the
temperature above the 2 dots (••) to avoid this issue.
Chapter 2.2 - Ironing
Dry Ironing
Select the temperature of the soleplate following the indications of chapter
2.1. Start your ironing without pressing the steam trigger (11), when the
soleplate reaches the appropriate temperature.
Steam Ironing
Select the temperature of the soleplate following the indications of chapter
2.1. The steam will be ready to be used after iron light (10) disappear. From
that time you can begin ironing and use the steam trigger. The steam flow
stops when you release the trigger.
N.B.
During use, "it is normal to experience some noise coming from your steam
generator. It signifies that a pump injects water into the boiler.
5 - GB
Fig. 6: Pressing Steam
Trigger Graphic