Werbung
Verfügbare Sprachen
Verfügbare Sprachen
that the cable is not tense during mounting, with a proper margin
reserved to avoid poor port contact or loosening caused by shock
or shake.
During transportation, special attention is required to protect the
transparent dome cover from friction, scratch and stain, etc. Do not
remove the protective film from the cover until mounting is finished.
Remove the protective film before powering on the device.
Make sure the wall or ceiling is strong enough to support the weight
of the camera. If dust falls during mounting, take off the dome cover
and keep it away from dust. Install the dome cover after the base is
installed.
Contact professionals for maintenance information. Do not attempt
to dismantle the device by yourself. We shall not assume any
responsibility for problems caused by unauthorized repair or
maintenance.
Maintenance
If there is dust on the front glass surface, remove the dust gently
using an oil-free brush or a rubber dust blowing ball.
If there is grease or a dust stain on the front glass surface, clean the
glass surface gently from the center outward using anti-static gloves
or an oil-free cloth. If the grease or the stain still remains, use
anti-static gloves or an oil-free cloth dipped with detergent and
clean the glass surface gently until it is clean.
Do not use organic solvents (such as benzene and alcohol) to clean
the transparent dome cover.
4
EN
Werbung
