PIEPS DSP Bedienungsanleitung Seite 19

S E C O n dA R Y AVA L A n C H E
only if a rescuer wears an active transmitter, is the rescuer
perfectly equipped in case of a secondary avalanche. The automatic
fall-back function „Search to Send" or AUTOREVERT on a searching
beacon could possibly cause confusion and could potentially extend
the time involved in a search. Therefore PIEPS recommends to
deactivate the fall-back or AUTOREVERT function in every beacon
and instead use an emergency transmitter such as the PiePs Backup.
The PiePs Backup is a mini emergency-transmitter (frequency 457
kHz) that is worn in additional to the PIEPS DSP/DSP Tour directly on
the body and only starts to transmit in case of an emergency. So PIEPS
provides the first 100% solution for locating in case of a possible
secondary avalanche!
More information about the PIEPS Backup can be found on
www.pieps.com
C A R R Y I n G H A R n E S S
Carry your PIEPS DSP/DSP TOUR using the supplied
carrying harness on your body and outside the innermost
layer of clothing. The clasp on the safety line should be
connected to the appropriate strap (=recommended and
safest option).
There is also the option to carry the PIEPS DSP/DSP Tour
in a securely closeable trouser pocket without a protective
case, though here it is important to fix the safety line to
the clothing in an appropriate way so as to rule out losing
the avalanche transceiver.
IMPORTAnT! Always carry the PIEPS DSP/DSP Tour with
the display towards your body and under as many layers of
clothing as possible, as near as possible to your body.
30 | 08/11
All manuals and user guides at all-guides.com
S O F T WA R E u P dAT E
Every PIEPS DSP/DSP Tour can be tested and updated with the
latest PIEPS firmware. With your safety in mind our R&D team
is constantly working on improving the firmware to reflect and
incorporate all our experiences in the field. Every new firmware is
developed to be compatible with any PIEPS DSP/DSP Tour. You can
have your PIEPS DSP/DSP Tour checked and its firmware updated
at every PIEPS Service Center and PIEPS distributor.
How can you display your firmware?
When you are switching the beacon on the latest
firmware is indicated on the display.
IMPORTAnT! For more information to the PIEPS firmware see www.pieps.com.
PIEPS dSP | PIEPS dSP TOuR (8.2)
Smart transmitter
iPROBE Support
iPROBE Support optimized
Wattage optimized (iPROBE Support)
Frequency measurement (only DSP)
Old beacon mode
MARK function optimized
SCAN function advanced (only DSP)
Self Check
TX600 Search (only DSP)
2.8 3.1 4.0 5.0 6.2 8.2
– –
✓ ✓ ✓ ✓
– – –
✓ ✓ ✓
– – – –
✓ ✓
– – – –
✓ ✓
–
✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓
– – –
✓ ✓ ✓
– – –
✓ ✓ ✓
– – – – –
✓
08/11 | 31