Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting the alarm:
Rotate the alarm setting wheel on the rear side of the clock until the alarm
hand is in the desired position
Repeatalarm& light:
1. Press the SNOOZE/LIGHTbutton on the top of the clockto activate the
backlight for three seconds and temporarily stop the alarm
2. After approx. five minutes, the alarm will start again
Switching the alarm on/off:
1. Move the Alarm ON/OFFswitch into the ON position to switch on the
alarm. A red dot appears on the clock face
2. Move the Alarm ON/OFFswitch into the OFFposition to switch off the
alarm. A green dot appears on the clock face
Specifications:
Integrated radio receiver for receiving the DCF77 time signal
1. Operating voltage range:
2. Battery type:
3. Synchronisation with transmitter time:
4. Automatic change between summer and winter time
5. Changeduration:
Possible
sources
of interference:
1_ Household appliances
2. TV sets less than 2m away
3. Machines with HF leakage fields
Problems:
1_ The hands do not move after you have inserted the battery
2. The clock does not set itself to the correct
ved a radio signal for 10 nmnutes after you have inserted tha battery
6
1 25-1.75
V
12times a day
Approx five minutes
time because
it has not recei-
Solutions:
1. Check the battery voltage, battery contact and polarity
2. Setupthe clockin a differentlocation,e.g.neara window, or rotateit
by 90 degrees
3. Take out the battery and reinsert it after a few minutes.
4. If there is something wrong with the transmitter, wait for afew hours, then
repeat the start-up procedure.
Replacingthe battery:
Please use only the types of battery that are approved for this device and
ensure that the polarity is correct when inserting a new battery
7
Werbung
