Seamaid 500699 Montage-& Wartungshandbuch Seite 6

6. OPERATION
The system offers 10 programs including 7 static colours and 3 automatic modes.
The control is made manually by the remote controller provided and also short cuts of the current.
Each fast cut of the current (less than 2 seconds) makes change the programs. After leaving the
lamps OFF for over 10 seconds, switch ON restarts from the last program used.
The use of the remote controller requires a positioning facia to the lamp at a maximum distance of 10
meters, unfolded antenna. Metallic part closed to the lamp can cut the radio reception and the distance
of use under 1 to 2 meters.
At first use, the remote controller needs to be paired with the receiver installed in the projector.
>>> Pairing process : (connect to a socket provided with interrupter)

Install the battery in the remote controller and switch on the projector

Switch it OFF for a minimum of 20 seconds and turn ON the current again

Make fast OFF/ON/OFF/ON from the power supply of the lamp(s)

Press the buttons O & S together during 1 second

Each lamp connected flash several times to valid the pairing and keep a static colour
Press several times the button C or P until obtaining the colour or the desired program.
7. SAFETY WARNINGS
> Before any operation ensures that the main power supply is turned OFF
> All electrical connections must be made out of water
> Do not handle with wet feet
> Comply with the current standards regarding accident prevention
> In this regard, the IEC 364-7-702 standards must be observed : WIRING IN
BUILDINGS, SPECIAL WIRING, SWIMMING POOLS.
> The persons in charge of the assembly of this product must have the qualification
required for this kind of work.
> Stop by the remote corresponds to a standby mode. If stopping over 24 hours, it is
recommended to use the switch located upstream of the transformer
8. GUARANTEE
This LED projector is guaranteed 24 months against any material and/or manufacture defect
(electronic components) from the date of delivery. (Keep the purchase invoice/receipt)
The projector is not guaranteed against problems coming from external shock, electric short-circuit or
excessive screwing. The product is not guaranteed against electrical excessive voltage coming from
the external power supply. (In this case, refer to the house insurance coverage)
This guarantee is conditioned with the strict respect of these instructions of assembly and
maintenance. Under this guarantee, the only obligation falling on the manufacturer or distributor will be
the free replacement or repair of the product or the element found defective by their after sale
services. All the other expenses will be the responsibility of the purchaser. For any replacement or
repair, the product must be subjected to an inspection to the after-sales service of the manufacturer or
distributor.
The guarantee does not play in the event of apparent vice.
The defects and deteriorations caused by the fair wear and tear, the defects resulting from a wrong
assembly and/or employment, and the modifications of the product carried out without the written and
preliminary assent of the manufacturer are all also excluded.
9. ENVIRONMENTAL INFORMATION
In accordance with the European Directive 2002/96/CE, concerning the electric and
electronic component scrap (EEED), the consumer must turn over the used product to
the collect points envisaged to this end.
All manuals and user guides at all-guides.com