Werbung
1.3.5. Removing a tyre
Use the valve driver to let the air out of the tyre.
The tyre bead must first be completely pressed off from both sides
of the rim with the mounting plate. During this process, the
mounting paste is applied to the rim and the tyre bead.
The first bead with rim mounting hook is now mounted.
Feed the mounting hook between the bead and the rim.
The tyre is then levered over the rim by lowering the rim and
pulling the mounting hooks.
Turn counterclockwise to remove the bead.
Now remove the second bead with the bead breaker.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
WARNING!!
Note that the most secure tension is always at the inner hole.
WARNING!!
Never leave the work area while the wheel is still raised or tensioned.
Manufacturer ATH-Heinl GmbH & CO.KG
- 8 -
Werbung
