Bathing In The Twinline - Artweger TWIN:LINE 2 Montageanleitung

1.) Move the locking element to "Duschposition"
("Showering position"). The door is not locked, the
drain is open.
2.) By lifting the end of the handle upwards you open
the shower door inwards.
3.) When you shut the door it clicks into place
automatically and remains in this position.
4.) Move the locking element to "Badeposition"
("Bathing position"). Now the door is locked; it is
no longer possible to open it. At the same time the
drain is closed off. Now you can fill the bathtub.
5.) After having taken your bath, return the locking
element to the "Duschposition" ("Showering
position").
Now the drain is open again, the water runs out and
the door is unlocked.
Applies only to the Whirlpool Twinline Air:
The jets are automatically blow dried after showering.
This process begins approximately 20 minutes after
the end of the shower and lasts for approximately
3 minutes.
ATTENTION: Wait to open the door until all the water has run out! Never leave children or
persons with general learning disabilities unsupervised!
All manuals and user guides at all-guides.com
BATHING
IN THE TWINLINE
16