ELEMENTI OFG101 Handbuch Seite 22

Possible Cause 5: High Winds
-Your fire table is designed to operate in winds up to 3 m/s. High winds may cause the flame to
blow out. Do not operate your fire table in high wind conditions.
Problem: Burner flame is low.
Note:Do not operate appliance below 5℃
Possible Cause 1: Outdoor temperature is greater than 5℃ and gas bottle is less than 25% full.
-Replace gas bottle with a new one.
Possible Cause 2: Gas pipe is bent or kinked.
-Straighten hose and perform leakage test on gas pipe.
Other Problem
Carbon build-up
Possible Cause: Dirty or film on burner.
-Clean burner.
Flash black(flame inside burner)
Possible Cause: Burner ports are blocked.
-Switch OFF the appliance. Close gas cylinder valve. Wait 2 minutes, following the ignition
procedure. Ignite burner. If problem continuous, switch-off. Contact your dealer.
Thick Black smoke
Possible Cause:Blockage in the burner.
-Turn control knob to "OFF" position, let the appliance to cool at room temperature and remove
blockage and clean burner inside and outside.
TROUBLESHOOTING
22 / 112