ELEMENTI OFG101 Handbuch Seite 15

Connect the natural gas to the unit
1. Attach the hose to the manifold inlet fitting with a national standard NG connector and secure the
hose to the manifold inlet fitting.
Ensure that all connecting threads and surfaces are undamaged and clean. When fitting the hose
make sure that it is free from twisting, kinks or sharp bends. Protect the hose from any sharp edges.
2. Attach one end of the hose to the main shut off valve of city network gas.
3. Do a leak test each time when the gas connection is reconnected. lf the hose shows deterioration
or damage, leak test the entire outer surface. Remember to turn the city network gas OFF before
removing the hose.
• Installation and service must be performed by a qualified installer,
service agency or gas supplier.
• Improper Installation, adjustment, alteration, service or maintenance
can cause injury or property damage.
Placing the battery
Make sure the gas supply system is turned to "OFF". Install the AAA battery as shown in the diagram
below.
Control panel
INSTALL
!
WARNING
Fire table
15 / 112
_
+