Factory Setting - OEM RD 61112 K Bedienungsanleitung

4. Timer information (timer "M")
4.1 Weekdays
Weekdays
The Control variant allows the programming of the heating phases
in memory "M". It is possible to program the working week (Mon-
Fri), the weekend or all weekdays individually.
Heating phases
2 heating phases can be set per day (e. g. 5:30 am to 12:45 pm and
5:00 pm to 10:15 pm). The last possible 2nd switch-off time is 11:45
pm, the earliest possible 1st switch-on time is 00:15 am.
A day-overlapping programming of heating phases (e. g. from 5
pm to 1 am) is impossible.
The temperature is reduced by 2-6 K from the target temperature
in the times not programmed.
Summer and winter time
Summer and winter time must be set manually due to the fact that
no date is programmed.

4.2 Factory setting

Factory setting: An adaptation to the target temperature is
performed
• Mon-Fri, 5-8 am and 3-10 pm
• Sat-Sun, 6 am - 11 pm
In the remaining time there is a temperature reduction of 2-6 K.
Position 5.1.6
Resetting to factory settings is possible by pressing
of 5 seconds after programming step 5.1.6. All previously made
settings are deleted (factory setting). After that, position 5.1.7 is
displayed. Start the new programming now.
Control
"CLr", "ALL" flash
alternately = possibility
to set the timer back
to factory settings.
for a duration
Control