Assembly In Connection With Lunotherm And Lunotherm Fs - Lunos Ald-R 160 Einbauanleitung

Remove the plaster protection
caps. Insert the external closure.
Mount the covering frame of the
inner screen. In doing so, note that
the lettering "LUNOS" is readable
at the bottom right. Insert the filter.
Snap the design screen of the
inner screen into place in open
position.

Assembly in connection with LUNOtherm and LUNOtherm FS

Note: For the assembly of the wall-tube 9/RD 160 and the facade element LUNOtherm or
LUNOtherm FS please refer to the corresponding installation manuals.
The sound absorber endpiece is included in the delivery of LUNOtherm or
Insert the sound absorber endpiece as
pictured und push it to the front edge
of the pipe. With the facade element
assembled, the pipe has a stop up to
which the sound absorber endpiece
can be pushed. If necessary, reduce
the sound-absorbing elements of the
ALD-R 160 in such a way that the
outlined distance of 127 mm to the
pipe edge remains the same. This
distance is covered by the styrofoam
coating of the wind pressure relief.
(This distance does not apply to the
version ALD-S).
Continue the assembly as described in the chapters on assembly
18
④
Covering
frame
Design
screen
Filter
LUNOtherm FS.
Sound absorber
endpiece
down
of the ALD-R 160 and ALD-S.
127 mm
outside
EN
Outer grille
EN