Shipping Units; Assembly: Ald-R 160 - Lunos Ald-R 160 Einbauanleitung

Shipping units

Please check the delivery for completeness and mint condition!
ALD-R 160
ALD-R 160 Built-in device
9/WDS 160
+ Filter
+ Airflow regulator
ALD-S
ALD-S Built-in device
Sound insulation ring
+ Filter

Assembly: ALD-R 160

Prepare the wall opening for the wall-tube
(e.g. via core drilling, core bit Ø162 mm).
If necessary, shorten the wall-tube to the
installation length required. In doing so, en-
sure the necessary excess length of the tube
on both sides to bridge the plaster thickness.
If necessary, reduce the sound-absorbing
elements in such a way that the outlined dis-
tances to the pipe edge remain the same.
If necessary, shorten the outer star-shaped
sound-absorbing element e.g. using a cutter
knife. Insert the wall-tube and seal it all around
(assembly adhesive Order No. 038 733).
Apply the internal and external plaster. In the
case of an external closure to be plastered,
first replace the plaster protection cap outside
with the external closure.
Sound-absorbing elements (3 pieces
- please order two additional sound-
absorbing elements when using the full
pipe length 500mm)
Metal sound-
absorbing ele-
Sound-absorbing elements (4 pieces
- please order two additional sound-
absorbing elements when using the full
pipe length 500mm)
①
inside
3 mm
slope (if
required,
support
using wed-
ges - Order-
No. 039 938)
②
inside
+ Wall-tube
+ Inner screen
+ External closure
+ Wall-tube
+ Inner screen
+ External closure
127 mm min. 20 mm*
* only when mounting with
outer grilles Type 1/...E 180
EN
outside
outside
15